CIM Issues #6549
Updated by David Haynes 9 months ago
There are many relays controlling many loads. Sometimes these assets can be switched on or off for different reasons. While working on lines, it is a common practice to employ "lock out / tag out" procedures. In this scenario, the workman physically places a padlock on a switch to prevent its movement. Then, at the end of the job the workman physically removes his padlock to restore normal operation of the switch. While the safety issue is nicely handled by the physical locks, an operational issue still remains. What if a CIS declares that a particular RCD switch inside of a revenue meter is to be opened due to non-payment. Then what if this same switch is made available to the DERMS for load control purposes? A DR system might (even as part of a group) ask that the switch participate in a load shed, then upon completion, that the switch be closed in. What is the switch to do? How would it know to revert to an open position? What if that is obsolete information? What are the expectations for the AMI network / load control system? Should there be a "system of record" that is the official keeper of allowable switching activity? Should there be the means for a back office system to effectively place a "lock" on a switch position and prevent other back office systems from operating it? Can multiple systems place locks similar to the physical lockout/tagout mechanism described above? Or rather, should there be a "list"? Should there be a "do not open" list and a "do not close" list? (Someone might be on life support, someone may have moved out, etc.)
Meters con not only have a big 200A disconnect, they might have a number of small relays designed to control individual loads like irrigation pumps, or anything else the utility wires them to.
There are also specialized switches the AMI network might control -- usually installed beneath a given revenue meter -- to control smaller loads within a home. Should these be lockable too?
We can't have multiple systems fighting over the switch position. We need a switch management plan.
This issue is related to Issue #6542.
For discussion purposes, we think the scope of this issue is limited to switches that are not on the feeder that a lineman could interact with. These switches are covered by Part 3. But there are switches that are otherwise safe to operate that are in scope.